OEM 2009 Dodge Viper Speed Sensor

2009 Dodge Viper Speed Sensor Parts and Q&A

• Q: How to Remove and Replace a Speed Sensor on 2009 Dodge Viper?

  A: Start removing and replacing the wheel speed sensor by fitting the wheel speed sensor head (2) into the steering knuckle (1) and holding it tight with the mounting bolt (3) after tightening to 11 Nm (100 in. lbs.). After that, run the sensor harness beside the brake flex hose and fasten it where the clips are provided. Put the fastener clip of the sensor connector into the mounting hole and link the sensor connector to the wiring harness in the vehicle. After that, attach the wheel assembly to the vehicle, tightening each nut that holds the wheel in place to 135 Nm (100 ft. lbs.). After lowering the car, verify the vehicle's status and fix any problems you find.