How to Maintain the Brake Light Switch on 2009 Jeep Commander?

Before servicing the brake light switch, unhook and isolate the battery negative cable, disconnect the SRS and wait for two minutes to make sure there's no air bag problem. Take off the steering column cover on the instrument panel before you start. Rotate the brake lamp switch housing back about 30 degrees while you push the brake pedal, so the tabs on the switch collar align with the hole in the bracket of the pedal. Take the keyed switch from its holder directly to the side, then step on the brake pedal again. Last, remove the wire harness connector from the brake lamp switch.

OEM 2009 Jeep Commander Brake Light Switch

Brake Lamp Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Brake Light Switch found

View related parts
2009 Jeep Commander Lamp Switch Part Number: 56054001AD
$37.64 MSRP: $54.10
You Save: $16.46 (31%)
ADD TO CART
Product Specifications
- Other Name: Switch - Stop Lamp; Brake Light Switch; Stoplamp Switch; Switch; Switch Stop Lamp
- Replaces: 56054001AB, 56054001AC, 56054001AA
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.9 x 2.3 x 3.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56054001AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2009 Jeep Commander Submodels:
- 65th Anniversary Edition, Base, Limited, Overland, Sport | 3.7L V6, 4.7L V8, 5.7L V8, 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L GAS

2009 Jeep Commander Brake Light Switch Parts and Q&A

Q: How to Maintain the Brake Light Switch on 2009 Jeep Commander?
A: Before servicing the brake light switch, unhook and isolate the battery negative cable, disconnect the SRS and wait for two minutes to make sure there's no air bag problem. Take off the steering column cover on the instrument panel before you start. Rotate the brake lamp switch housing back about 30 degrees while you push the brake pedal, so the tabs on the switch collar align with the hole in the bracket of the pedal. Take the keyed switch from its holder directly to the side, then step on the brake pedal again. Last, remove the wire harness connector from the brake lamp switch.