How to Install a Yaw Sensor on 2010 Dodge Caliber?

The first thing to do is connect the wiring harness connector to the dynamics sensor. Lay the dynamics sensor on top of the tunnel studs screwed into the body section and use the two mounting nuts to hold it in place by tightening them to 9 Nm (80 in. lbs.). Return the carpet to where it was and fasten the shifter housing into its proper hole. Connect the negative battery cable to the appropriate post, carry out the Verification Test and verify that no errors appear.

OEM 2010 Dodge Caliber Yaw Sensor

Yaw Rate Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Yaw Sensors found

View related parts
2010 Dodge Caliber Yaw Rate Sensor Part Number: 56029482AA
Product Specifications
- Other Name: Module - Dynamics; Control Module; Stab Control Module; Sensor Dynamics Lateral Acceleration And Yaw Rate
- Item Weight: 0.80 Pounds
- Item Dimensions: 8.1 x 4.1 x 3.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56029482AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2010 Dodge Caliber Submodels:
- Express, Heat, Mainstreet, R/T, Rush, SE, SRT-4, SXT, Uptown | 4 Cyl 1.8 L GAS, 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L GAS
View related parts
2010 Dodge Caliber Yaw Rate Sensor Part Number: 56029429AA
Product Specifications
- Other Name: Sensor - Dynamics; Control Module; Stab Control Module; Sensor Dynamics Lateral Acceleration And Yaw Rate
- Item Weight: 1.40 Pounds
- Item Dimensions: 6.5 x 6.5 x 3.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56029429AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2010 Dodge Caliber Submodels:
- Express, Heat, Mainstreet, R/T, Rush, SE, SXT, Uptown | 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L GAS

2010 Dodge Caliber Yaw Sensor Parts and Q&A

Q: How to Install a Yaw Sensor on 2010 Dodge Caliber?
A: The first thing to do is connect the wiring harness connector to the dynamics sensor. Lay the dynamics sensor on top of the tunnel studs screwed into the body section and use the two mounting nuts to hold it in place by tightening them to 9 Nm (80 in. lbs.). Return the carpet to where it was and fasten the shifter housing into its proper hole. Connect the negative battery cable to the appropriate post, carry out the Verification Test and verify that no errors appear.