The first step is to raise and support your vehicle, then make sure to remove the wheel and tire assembly. After that, detach the brake caliper, adapter and rotor from the hub, as well as the wheel speed sensor. Use the special tool C-4150A to push on the stud coming from the hub. Put the stud into the hub flange, then slide three suitable washers onto the stud. Before finishing, install a lug nut with its flat side opposite the washers. Keep tightening the lug nut so the stud is pushed securely into the hub flange and it is sitting properly. Lift the rotor, adapter and caliper together, release the brake drum, then rotate and install the brake drum last. Next, install the replaced lug nut on the wheel's stud and put the wheel and tire assembly on the car, then suspend the vehicle and remove the support.