How Does a Brake Fluid Level Sensor Work and Require Servicing on 2005 Jeep Grand Cherokee?

Begin by pulling the wire connector from the sensor before proceeding. To continue, open the sensor locking tabs just below the reservoir, while using a small screwdriver and pull the sensor from inside the reservoir through its connector. To set up the sensor, open the reservoir lid, put the O-ring on the sensor's end and line the sensor up so both locking tabs slide into the port on the reservoir. After that, reconnect the wire connector to the sensor.

OEM 2005 Jeep Grand Cherokee Brake Fluid Level Sensor

Brake Fluid Liquid Level Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Brake Fluid Level Sensor found

View related parts
2005 Jeep Grand Cherokee Fluid Level Sensor Part Number: 5013903AA
Product Specifications
- Other Name: Sensor - Brake Fluid Level; Brake Fluid Level Switch; Fluid Sensor; Sensor Brake Fluid Level
- Item Weight: 0.40 Pounds
- Item Dimensions: 2.5 x 1.2 x 0.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5013903AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2005 Jeep Grand Cherokee Submodels:
- 65th Anniversary Edition, Laredo, Limited, Overland, SRT8 | 6 Cyl 3.0 L DIESEL, 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L GAS, 8 Cyl 6.1 L GAS

2005 Jeep Grand Cherokee Brake Fluid Level Sensor Parts and Q&A

Q: How Does a Brake Fluid Level Sensor Work and Require Servicing on 2005 Jeep Grand Cherokee?
A: Begin by pulling the wire connector from the sensor before proceeding. To continue, open the sensor locking tabs just below the reservoir, while using a small screwdriver and pull the sensor from inside the reservoir through its connector. To set up the sensor, open the reservoir lid, put the O-ring on the sensor's end and line the sensor up so both locking tabs slide into the port on the reservoir. After that, reconnect the wire connector to the sensor.