OEM 2005 Jeep Liberty Vapor Canister

2005 Jeep Liberty Vapor Canister Parts and Q&A

• Q: How to Remove and Install a Vapor Canister on 2005 Jeep Liberty?

  A: You'll find the EVAP canister next to the left/rear spring perch, just by the fuel tank. Jack the car up, unplug the vacuum hoses at the EVAP canister, remembering their locations before taking them off. Detach the EVAP canister and mounting bracket set from the body by undoing the 2 bolts that secure them and then remove the bolt between the canister and the bracket. Push the mounting pins in your mounting bracket out so they can slide out. Slide the two mounting pins into the bracket, insert the bolt at the base of your canister and put the whole assembly in place on your car. Screw the two bolts through to the bolt holes in the engine and tighten them to 47 N-m (35 ft. lbs.). Join the vapor/vacuum lines to the EVAP canister and check that there aren't any leaks on the lines after the NVLD pump, filter and EVAP canister purge solenoid. Don't forget to lower the hitch after everything is hooked up.