How to Remove and Install a MAP Sensor on 2006 Dodge Dakota?

The MAP sensor is located embedded in the front of the intake manifold. Remove the sensor by unclipping the electrical connector from the sensor first then the area of the sensor. Next, remove the two mounting sensor screws and remove the MAP sensor from the intake manifold. At this point check the condition of the sensor O ring. The MAP sensor mounting hole at the intake manifold should be cleaned for installation and the O ring seal checked for cuts or tears. Fit the sensor into the manifold, bolt down the mounting bolts and connect the electrical connector according to the Torque Specifications.

OEM 2006 Dodge Dakota MAP Sensor

Manifold Air Pressure Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 MAP Sensor found

View related parts
2006 Dodge Dakota M.A.P. Sensor Part Number: 56041018AD
$97.73 MSRP: $149.00
You Save: $51.27 (35%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Map; Manifold Absolute Pressure Sensor; Manifold Sensor; MAP Sensor; Sensor Map; Pressure Sensor
- Replaces: 56041018AC
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.9 x 2.6 x 3.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56041018AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2006 Dodge Dakota Submodels:
- Base, Big Horn, Laramie, Lone Star, R/T, SLT, SLT Plus, ST, SXT, Sport, Sport Plus, TRX, TRX4 | 3.7L V6, 4.7L V8, 6 Cyl 3.7 L GAS, 6 Cyl 3.9 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.9 L GAS

2006 Dodge Dakota MAP Sensor Parts and Q&A

Q: How to Remove and Install a MAP Sensor on 2006 Dodge Dakota?
A: The MAP sensor is located embedded in the front of the intake manifold. Remove the sensor by unclipping the electrical connector from the sensor first then the area of the sensor. Next, remove the two mounting sensor screws and remove the MAP sensor from the intake manifold. At this point check the condition of the sensor O ring. The MAP sensor mounting hole at the intake manifold should be cleaned for installation and the O ring seal checked for cuts or tears. Fit the sensor into the manifold, bolt down the mounting bolts and connect the electrical connector according to the Torque Specifications.