How to Remove and Install a MAP Sensor on 2005 Dodge Dakota?

The MAP sensor sits into the front of the intake manifold. First, disconnect electrical connector from the sensor and clean it around the area. Then, pull out the MAP sensor from the intake manifold, remove the two sensor mounting screws and check the condition of the sensor O ring. Clean the MAP sensor mounting hole at the intake manifold and inspect O ring seal on MAP sensor for cuts or tears. Install the MAP sensor mounting screws per Torque Specifications and position the sensor into the manifold, then connect the electrical connector.

OEM 2005 Dodge Dakota MAP Sensor

Manifold Air Pressure Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 MAP Sensor found

View related parts
2005 Dodge Dakota M.A.P. Sensor Part Number: 56041018AD
$97.73 MSRP: $149.00
You Save: $51.27 (35%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Map; Manifold Absolute Pressure Sensor; Manifold Sensor; MAP Sensor; Sensor Map; Pressure Sensor
- Replaces: 56041018AC
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.9 x 2.6 x 3.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56041018AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2005 Dodge Dakota Submodels:
- Base, Big Horn, Laramie, Lone Star, R/T, SLT, SLT Plus, ST, SXT, Sport, Sport Plus, TRX, TRX4 | 3.7L V6, 4.7L V8, 6 Cyl 3.7 L GAS, 6 Cyl 3.9 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.9 L GAS

2005 Dodge Dakota MAP Sensor Parts and Q&A

Q: How to Remove and Install a MAP Sensor on 2005 Dodge Dakota?
A: The MAP sensor sits into the front of the intake manifold. First, disconnect electrical connector from the sensor and clean it around the area. Then, pull out the MAP sensor from the intake manifold, remove the two sensor mounting screws and check the condition of the sensor O ring. Clean the MAP sensor mounting hole at the intake manifold and inspect O ring seal on MAP sensor for cuts or tears. Install the MAP sensor mounting screws per Torque Specifications and position the sensor into the manifold, then connect the electrical connector.