How to Install Blower Control Switches on 2007 Chrysler Pacifica?

Before installing the blower motor switch, set both rear heated seat switches (2) into the back of the floor console cover (1), ensuring all the switch locking tabs are attached. After that, connect the wire harness terminals (4 and 7) to both the rear blower motor switch (5) and the rear heated seat switches. You should then connect the rear console switch bezel to its housing on the rear floor console (6) by pushing it in from the front so that the retaining tabs (3) are used. Next, put in the rear floor console and make sure the negative battery cable is once again connected.

OEM 2007 Chrysler Pacifica Blower Control Switches

HVAC Control Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Blower Control Switches found

View related parts
2007 Chrysler Pacifica Blower Motor Switch, Rear Part Number: UB51XDVAC
Product Specifications
- Other Name: Switch - Rear Blower; Blower Control Switch; Switch; Switch Rear Blower
- Position: Rear
- Item Weight: 0.80 Pounds
- Item Dimensions: 8.0 x 3.8 x 3.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: UB51XDVAC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Chrysler Pacifica Submodels:
- Base, LX, Limited, Touring | 6 Cyl 3.5 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 4.0 L GAS
View related parts
2007 Chrysler Pacifica Heater Control Part Number: 5005469AC
Product Specifications
- Other Name: Control - A/C And Heater; HVAC Temperature Control Panel; Climate Control Module; Blower Control Switch; Dash Control Unit
- Replaces: 5005469AB
- Item Weight: 1.70 Pounds
- Item Dimensions: 13.8 x 6.1 x 4.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5005469AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Chrysler Pacifica Submodels:
- Base, LX, Limited, Touring | 3.8L V6, 4.0L V6, 6 Cyl 3.8 L GAS, 6 Cyl 4.0 L GAS

2007 Chrysler Pacifica Blower Control Switches Parts and Q&A

Q: How to Install Blower Control Switches on 2007 Chrysler Pacifica?
A: Before installing the blower motor switch, set both rear heated seat switches (2) into the back of the floor console cover (1), ensuring all the switch locking tabs are attached. After that, connect the wire harness terminals (4 and 7) to both the rear blower motor switch (5) and the rear heated seat switches. You should then connect the rear console switch bezel to its housing on the rear floor console (6) by pushing it in from the front so that the retaining tabs (3) are used. Next, put in the rear floor console and make sure the negative battery cable is once again connected.