OEM 2007 Chrysler PT Cruiser Blend Door Actuator

2007 Chrysler PT Cruiser Blend Door Actuator Parts and Q&A

• Q: How to Install a Blend Door Actuator on 2007 Chrysler PT Cruiser?

  A: Place the actuator in the vehicle and mount it to the left of the HVAC air inlet housing. Should it be necessary, turn the actuator slightly so the pin on the lever lines up with the groove on the recirculation door lever. Shift the distribution duct on the right side of the floor to the side, then attach the recirculation door actuator to the air inlet housing using screws and fasten them to 2 Nm (17 in. lbs.). Link the wire harness connector to the recirculation door actuator and then connect the right floor distribution duct to the right rear floor duct and to the outlet next to the right side of the HVAC air distribution housing. Install a floor distribution duct by screwing it to the air distribution box with a 17 inch-pound (2 Nm) torque. After that, install the floor center console, glove box and passenger side instrument panel silencer and link the negative battery cable back again.