OEM 2009 Dodge Ram 2500 Air Bag Sensor

2009 Dodge Ram 2500 Air Bag Sensor Parts and Q&A

• Q: How to Service the Air Bag Sensor on a Quad Cab on 2009 Dodge Ram 2500?

  A: To avoid harm when handling the Quad Cab's side impact sensor, begin by disabling the SRS, then remove and disable the battery negative cable for two minutes to let the system capacitor discharge. Carefully avoid hitting or dropping the side impact sensor, as any damage or incorrect calibration may happen; the sensor should be replaced in case of a drop. Place the side impact sensor into the big hole above the retractor mounting hole in the inner B-pillar and secure the harness connector to the sensor connector in the car's side rail. Condense your hand through the large entrance to link the anti-rotation pin and the stud on the side impact sensor into the slot and mounting hole in the B-pillar. Carefully fix the side impact sensor stud to the B-pillar and tighten it to 8 Nm (70 in. lbs. ). Do not attach the battery negative cable again until after you have run the SRS verification test after servicing any part of the SRS system.