How to Service and Repair an ABS Control Module on 2001 Jeep Wrangler?

Before doing anything, take off the negative terminal from the battery. After that, take out the connector for the harness that is under the instrument panel, unbolt the mounting bolt there and remove the CAB. To install, fit the controller and fasten it in place with the mounting bolt, limited to 7 - 9 Nm (60 - 80 in. lbs.). Connect the harness connector to the controller and then install the negative battery cable.

OEM 2001 Jeep Wrangler ABS Control Module

Anti Lock Brake Control Module

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 ABS Control Modules found

View related parts
2001 Jeep Wrangler Control Assembly Part Number: 52128487AA
Product Specifications
- Other Name: Actuator - Anti-Lock Brake; ABS Control Module; Hydraulic Unit; Control Unit Anti-Lock Brake
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 52128487AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following 2001 Jeep Wrangler Submodels:
- 65th Anniversary Edition, Rubicon, SE, Sahara, Sport, Unlimited, Unlimited Rubicon, X | 4 Cyl 2.4 L GAS, 4 Cyl 2.5 L GAS, 6 Cyl 4.0 L GAS
View related parts
2001 Jeep Wrangler Control Module Part Number: 5073793AA
Product Specifications
- Other Name: Module - ABS; ABS Control Module; Module; Module Anti-Lock Brakes
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5073793AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following 2001 Jeep Wrangler Submodels:
- 65th Anniversary Edition, Rubicon, SE, Sahara, Sport, Unlimited, Unlimited Rubicon, X | 4 Cyl 2.4 L GAS, 4 Cyl 2.5 L GAS, 6 Cyl 4.0 L GAS

2001 Jeep Wrangler ABS Control Module Parts and Q&A

Q: How to Service and Repair an ABS Control Module on 2001 Jeep Wrangler?
A: Before doing anything, take off the negative terminal from the battery. After that, take out the connector for the harness that is under the instrument panel, unbolt the mounting bolt there and remove the CAB. To install, fit the controller and fasten it in place with the mounting bolt, limited to 7 - 9 Nm (60 - 80 in. lbs.). Connect the harness connector to the controller and then install the negative battery cable.