OEM 2008 Chrysler Sebring Tie Rod End

2008 Chrysler Sebring Tie Rod End Parts and Q&A

• Q: How to Install a Tie Rod End on 2008 Chrysler Sebring?

  A: You should first motion the jam nut down far enough on the inner tie rod threads so you can add the outer tie rod end. Move on by setting the outer tie rod onto the inner tie rod the same number of revolutions as you had during the original installation and skip tightening the jam nut for now. After that, mount the outer tie rod end into the hole in the knuckle arm and slip a new tie rod mounting nut over the stud. As you hold the tie rod end stud with a wrench, turn the nut until it achieves a torque of 85 Nm (63 ft. lbs.) with a wrench. Afterward, fit on the tire and wheel group and tighten the wheel mounting nuts to 135 Nm (100 ft. lbs.). Make sure the vehicle is lowered and adjust the toe on the front wheel. Set the jam nut on the tie rod to a tightness of 75 Nm (55 ft. lbs.) after you've adjusted the wheel toe.