Before working on the wiper switch, disconnect the battery negative cable first. Er. If your vehicle does not have a tilting steering column, loosen the upper two mounting nuts; but if the column can tilt, bring it down as far as it goes. Get rid of the upper shroud and the lower shroud on the steering column. After that, unscrew the two fasteners holding the switch water shield and bracket in place and the screw underneath the multi-function switch lever. Disengage the lower tab on the switch water shield bracket before lifting the shield and bracket which contains the multi-function switch, off the steering column's left side. If your car has a tilt steering wheel, moving the lever makes more room under the gear shift. To reach the wire harness connector, pull the windshield wiper and washer switch out past the right side of the steering column, remove the connector and then the switch. While doing the installation, do everything in the opposite order, with the upper switch mounting screws set to 22 Nm (200 in. lbs.), the lower switch water shield and bracket screw to 1.1 Nm (10 in. lbs.), the non-tilt steering column mounting nuts to 22 Nm (200 in. lbs.) and the steering column shroud mounting screws to 2 Nm (18 in. lbs.). With the rear wiper switch, once again disconnect and isolate the negative
Battery Cable and remove the center console bezel from the instrument panel. Pull away the accessory switch bezel by taking out the three screws holding it place and exposing the connector points. Remove the connectors from the back of the accessory switches, cigar lighter and power outlet after that, detach the accessory switch bezel. Insert a thin small bladed screwdriver into each snap clip at the rear wiper and washer switch receptacle on the switch bezel and gently pry the clips wider, then pull the switch out. installation for Awansvs 5pin, it is important to reverse how you took it off, secure both snap clip retainers on the switches fully and tighten the screws to 2.2 Nm (20 in. lbs.).