Other Name: Actuator - A/C And Heater; HVAC Air Inlet Door Actuator, Rear; HVAC Heater Blend Door Actuator; HVAC Blend Door Actuator; Actuator A/C And Heater Serviced With Distribution Housing; Actuator A/C And Heater
Position: Rear
Item Weight: 0.60 Pounds
Item Dimensions: 2.0 x 3.1 x 3.8 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 5061099AA
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2006 Dodge Caravan Submodels:
Base, C/V, SE, SXT | 4 Cyl 2.4 L GAS, 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS
2006 Dodge Caravan Blend Door Actuator Parts and Q&A
Q: How to Service the Blend Door Actuator on 2006 Dodge Caravan?
A: In order to service the Air Door Actuator/Motor on vehicles with air bags, remove and isolate the negative battery cable from the battery and wait a couple of minutes to allow the air bag system capacitor to discharge. The mixer door actuator is located in one place for a single zone unit, though there are two actuators in a dual zone system, each for their side. Slide the silencer out from its place underneath the driver side end of the panel. Take the wire harness connector off the blend door actuator and unscrew the two parts joining the actuator to the HVAC air distribution housing. After that, remove the actuator. When placing the new actuator, line up its output shaft splines with the blend air door linkage on the air distribution housing. Affix the actuator with the two screws that provide 2 N.m (17 in. lbs.) and then attach the HVAC wire harness connector again. After that, mount the silencer beneath the driver side end of the instrument panel, reattach the negative battery cable and adjust the A/C-heater control.