OEM 2006 Dodge Dakota Brake Line

2006 Dodge Dakota Brake Line Parts and Q&A

• Q: How to Maintain Brake Lines from the Axle Hose to the Wheel Cylinders on 2006 Dodge Dakota?

  A: Service the plastic lines that connect the rear brakes from the axles to the wheel cylinders by first supporting and raising the vehicle. If replacing brake line 3, take it off the brake hose 2 at the wheel axle, remove it from the clip on the spring bracket and then detach the other end from wheel cylinder 2. If you are replacing brake line 1, match that by disconnecting brake hose 2 from each end and remove both pieces. Disconnect the line being taken out, then place in the bend over tab along the axle and fold over the tab. Finally, attach the new brake line to the clip on the spring hanger. When trying this position, replace line 3 by attaching it to hose 2 at the axle and joining line 1 at cylinder 2. Should you change brake line 1, place it into the bend over tab at the axle, secure it to the spring hanger clip and join the free end to line 3 and wheel cylinder 2. Once that's done, drop the car off its supports, complete bleeding the brakes and then put everything back under the vehicle.