How to Install an Air Bag for Side Curtains on 2007 Jeep Liberty?

Before fitting a side curtain air bag, you should turn off the supplemental restraint system by disconnecting and isolating the battery negative cable for two minutes. Since handling an air bag may cause irritation, always use rubber gloves, glasses and a long-sleeved shirt. If you find that the air bag has not deployed, yet is either ineffective or damaged, take action as required for unreleased supplemental restraints. Install the side curtain air bag into the vehicle by joining the two halves and pushing the four plastic fasteners straight into their holes in the side rail. After you have installed the curtain inflator bracket snugly in the U-nut in the roof rail, add the upper screw and tighten it by hand; follow with the lower screw, tightening it to 12 Nm (105 in. lbs.). In the back, fit and tighten each screw holding the air bag manifold to its bracket on the roof rail, fixed with 12 Nm (105 in. lbs.) of tightening. Pass the side curtain air bag pigtail wire through the trough on top of the extruded plastic air bag channel and down the B-pillar, facing the rear. insert the three pigtail wire retainer clips into the B-pillar, then attach the pigtail wire connector to the body wire harness connector beside the base of the B-pillar. Insert the side curtain air bag tether plastic retainer clip into the A-pillar and attach the push-pin fastener that links the tether retainer to the base of the A-pillar by the belt line. Slide the headliner and lower trim back into the B-pillar's inside section. Please don't reconnect the SRS negative cable until the verification test is completed after any component servicing.

OEM 2007 Jeep Liberty Air Bag

Air Bag Module

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

8 Air Bags found

View related parts
2007 Jeep Liberty Inflator Curtain, Front Passenger Side Part Number: 55315098AE
$268.52 MSRP: $395.00
You Save: $126.48 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Airbag - Sidecurtain; Seat Air Bag, Front Right; Side Air Bag
- Position: Front Passenger Side
- Replaces: 55315098AD, 55315098AB, 55315098AC
- Item Weight: 8.00 Pounds
- Item Dimensions: 75.5 x 10.0 x 4.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 55315098AE
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Jeep Liberty Submodels:
- 65th Anniversary Edition, Limited, Renegade, Rocky Mountain Edition, Sport | 2.8L L4, 3.7L V6, 4 Cyl 2.4 L GAS, 4 Cyl 2.8 L DIESEL, 6 Cyl 3.7 L GAS
View related parts
2007 Jeep Liberty Inflator Curtain, Front Driver Side Part Number: 55315099AE
$290.05 MSRP: $427.00
You Save: $136.95 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Airbag - Sidecurtain; Seat Air Bag, Front Left; Side Air Bag
- Position: Front Driver Side
- Replaces: 55315019AF, 55315019AG, 55315099AC, 55315099AD, 55315099AB, 55315019AH
- Item Weight: 9.10 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 55315099AE
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Jeep Liberty Submodels:
- 65th Anniversary Edition, Limited, Renegade, Rocky Mountain Edition, Sport | 2.8L L4, 3.7L V6, 4 Cyl 2.4 L GAS, 4 Cyl 2.8 L DIESEL, 6 Cyl 3.7 L GAS
View related parts
2007 Jeep Liberty Passenger Air Bag, Upper Passenger Side Part Number: 55315103AF
$530.14 MSRP: $772.00
You Save: $241.86 (32%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Airbagg - Passenger; Instrument Panel Air Bag, Upper; Passenger Inflator Module; Air Bag Passenger
- Position: Upper Passenger Side
- Replaces: 55315103AD, 55315103AE
- Item Weight: 6.50 Pounds
- Item Dimensions: 16.2 x 11.6 x 9.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 55315103AF
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Jeep Liberty Submodels:
- 65th Anniversary Edition, Limited, Renegade, Rocky Mountain Edition, Sport | 4 Cyl 2.4 L GAS, 4 Cyl 2.8 L DIESEL, 6 Cyl 3.7 L GAS
View related parts
2007 Jeep Liberty Air Bag Door, Slate Gray, Passenger Side Part Number: ZE70XDHAB
$51.48 MSRP: $65.26
You Save: $13.78 (22%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Door - Passenger Air Bag; Door Passenger Air Bag Air Outlet Included (Heat Staked); Door Passenger Air Bag
- Position: Passenger Side
- Item Weight: 3.10 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: ZE70XDHAB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Jeep Liberty Submodels:
- Limited, Sport | 6 Cyl 3.7 L GAS
View related parts
2007 Jeep Liberty Air Bag Door, Passenger Side Part Number: ZE70ZJ8AB
$53.90 MSRP: $68.33
You Save: $14.43 (22%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Door - Passenger Air Bag; Door Passenger Air Bag Air Outlet Included (Heat Staked); Door Passenger Air Bag
- Position: Passenger Side
- Item Weight: 3.20 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: ZE70ZJ8AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Jeep Liberty Submodels:
- Limited, Sport | 6 Cyl 3.7 L GAS
View related parts
2007 Jeep Liberty Driver Inflator Module, Driver Side Part Number: 5JS061X9AF
Product Specifications
- Other Name: Airbag - Driver; Steering Wheel Air Bag; Driver Air Bag
- Position: Driver Side
- Replaces: 5JS061X9AE
- Item Weight: 4.30 Pounds
- Item Dimensions: 11.8 x 10.5 x 6.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5JS061X9AF
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Jeep Liberty Submodels:
- Sport | 2.8L L4, 3.7L V6, 4 Cyl 2.4 L GAS, 4 Cyl 2.8 L DIESEL, 6 Cyl 3.7 L GAS
View related parts
2007 Jeep Liberty Driver Air Bag, Slate Gray, Driver Side Part Number: 5JS061DHAF
Product Specifications
- Other Name: Airbag - Driver; Steering Wheel Air Bag
- Position: Driver Side
- Replaces: 5JS061DHAE
- Item Weight: 4.40 Pounds
- Item Dimensions: 15.9 x 10.1 x 6.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5JS061DHAF
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Jeep Liberty Submodels:
- 65th Anniversary Edition, Limited, Renegade, Rocky Mountain Edition | 2.8L L4, 3.7L V6, 4 Cyl 2.8 L DIESEL, 6 Cyl 3.7 L GAS
View related parts
2007 Jeep Liberty Driver Inflator Module, Driver Side Part Number: 5JS061J8AF
Product Specifications
- Other Name: Airbag - Driver; Steering Wheel Air Bag; Driver Air Bag
- Position: Driver Side
- Replaces: 5JS061J8AE
- Item Weight: 4.30 Pounds
- Item Dimensions: 11.6 x 10.2 x 6.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5JS061J8AF
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Jeep Liberty Submodels:
- 65th Anniversary Edition, Limited, Renegade | 2.8L L4, 3.7L V6, 4 Cyl 2.8 L DIESEL, 6 Cyl 3.7 L GAS

2007 Jeep Liberty Air Bag Parts and Q&A

Q: How to Install an Air Bag for Side Curtains on 2007 Jeep Liberty?
A: Before fitting a side curtain air bag, you should turn off the supplemental restraint system by disconnecting and isolating the battery negative cable for two minutes. Since handling an air bag may cause irritation, always use rubber gloves, glasses and a long-sleeved shirt. If you find that the air bag has not deployed, yet is either ineffective or damaged, take action as required for unreleased supplemental restraints. Install the side curtain air bag into the vehicle by joining the two halves and pushing the four plastic fasteners straight into their holes in the side rail. After you have installed the curtain inflator bracket snugly in the U-nut in the roof rail, add the upper screw and tighten it by hand; follow with the lower screw, tightening it to 12 Nm (105 in. lbs.). In the back, fit and tighten each screw holding the air bag manifold to its bracket on the roof rail, fixed with 12 Nm (105 in. lbs.) of tightening. Pass the side curtain air bag pigtail wire through the trough on top of the extruded plastic air bag channel and down the B-pillar, facing the rear. insert the three pigtail wire retainer clips into the B-pillar, then attach the pigtail wire connector to the body wire harness connector beside the base of the B-pillar. Insert the side curtain air bag tether plastic retainer clip into the A-pillar and attach the push-pin fastener that links the tether retainer to the base of the A-pillar by the belt line. Slide the headliner and lower trim back into the B-pillar's inside section. Please don't reconnect the SRS negative cable until the verification test is completed after any component servicing.