OEM 2009 Dodge Viper Heater Core

2009 Dodge Viper Heater Core Parts and Q&A

• Q: How to Install a Heater Core in the HVAC Housing on 2009 Dodge Viper?

  A: Following this, put the heater core into the upper part of the housing for the HVAC unit. Fit the heater core tube bracket and its retaining screw and tighten the screw to 2 Nm (17 in. lbs.). After that, attach the foam seal. Put the blend door actuator at the top of the HVAC housing and rotate it until you see that the splines on its shaft are properly lined up with those in the pivot of the blend door. Place the blend door actuator on the HVAC housing and secure it with screws set at 2 Nm (17 in. lbs.). Finally, join the wire harness connector to the actuator. If the heater core must be replaced, run a coolant flush on the entire system. After that, add the HVAC housing assembly.