Other Name: Control - A/C And Heater - Auxiliary; HVAC Temperature Control Panel; Climate Control Module; Blower Switch; Heater & A/C Control; Dash Control Unit; Controller; Control A/C And Heater - Auxiliary
Position: Rear
Item Weight: 1.00 Pounds
Item Dimensions: 10.2 x 6.3 x 5.2 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 5127844AA
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2004 Dodge Durango Submodels:
Adventurer, Limited, Limited Hybrid, SE, SLT, ST, SXT | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 5.7 L GAS
Other Name: Control - A/C And Heater; HVAC Temperature Control Panel; Climate Control Module; Blower Control Switch; Dash Control Unit; Control A/C And Heater
Other Name: Knob - A/C And Heater Control - Ro; HVAC Heater Control Knob, Lower; Controller Knob; Knob A/C And Heater Control - Rotary
Position: Lower
Item Weight: 0.40 Pounds
Item Dimensions: 2.1 x 2.1 x 1.2 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 5133149AA
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2004 Dodge Durango Submodels:
Adventurer, Limited, Limited Hybrid, SE, SLT, ST, SXT | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 5.7 L GAS
Other Name: Control - A/C And Heater; HVAC Temperature Control Panel, Front; Climate Control Module; Blower Control Switch; Dash Control Unit; Control A/C And Heater
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2004 Dodge Durango Submodels:
Adventurer, Limited, SLT, ST, SXT | 3.7L V6, 4.7L V8, 5.7L V8, 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L GAS
2004 Dodge Durango A/C Switch Parts and Q&A
Q: How to Operate the Rear A/C Switch for Heating Control on 2004 Dodge Durango?
A: Before servicing the rear A/C heater control, remove and set aside the negative battery cable. With a small screwdriver or other flat tool, gently push down the clip retainer that you find at both upper corners of the rear A/C heater control. Press downwards on the A/C heater control on the rear of the center console to let the bottom retaining tabs free from their slots. Unplug the wire harness from the control for the rear A/C heater, then remove the control from your car. When installing, attach the rear A/C heater control to the center floor console and join its harness connection to the back of the unit. Slide the two locator tabs on the rear A/C heater control into the two slots on the underside of the floor console aperture. Push forward on the A/C heater control until it clicks into place with the snap clips on the console's upper edge. Reset the negative battery cable and use a scan tool to adjust the settings of the Rear Temperature Selector potentiometer. Perform front A/C heater control Actuator Calibration and fix any problems that appear during the process. Each time, move the Rear Temperature Selector clockwise: first to Cold and leave it there for 5 seconds and next to Hot and again for 5 seconds. Calibration has finished successfully.