Menu
×
Search Bar
Search by Part Number, Part Name, or Vehicle
My Garage
Cart
Help Center Contact Us

OEM 2006 Dodge Durango Blend Door Actuator

Air Blend Door Actuator
  • Select Vehicle by Model
  • Select Vehicle by VIN
Select Vehicle by Model
Make
Model
Year
or
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Blend Door Actuator found

  • 2006 Dodge Durango Blend Door Actuator - 4885206AB
    2006 Dodge Durango Blend Door Actuator - 4885206AB
    2006 Dodge Durango Blend Door Actuator Diagram - 4885206AB
    View related parts

    2006 Dodge Durango Door Actuator Part Number: 4885206AB

    $137.09 MSRP: $202.00
    You Save: $64.91 (33%)
    Product Specifications
    • Other Name: Actuator - A/C And Heater; HVAC Air Adjustment Control Motor; HVAC Heater Blend Door Actuator; HVAC Blend Door Actuator; Actuator; Servo; A/C and Heater Actuator with Bracket, Lever, and Recirculation Door.
    • Item Weight: 0.70 Pounds
    • Item Dimensions: 1.9 x 3.6 x 4.2 inches
    • Condition: New
    • Fitment Type: Direct Replacement
    • SKU: 4885206AB
    • Warranty: This genuine part is guaranteed by Mopar's factory warranty.
    More Info
    Fits the following 2006 Dodge Durango Submodels:
    • Adventurer, Base, Limited, Limited Hybrid, R/T, SE, SLT, SLT Plus, ST, SXT, Sport | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 5.7 L GAS, 8 Cyl 5.9 L GAS

2006 Dodge Durango Blend Door Actuator Parts and Q&A

  • Q: How to Service and Repair a Rear Blend Door Actuator on 2006 Dodge Durango?
    A: Service and repair of the rear blend door actuator should start with disconnecting and isolating the negative battery cable. Pull out the rear quarter panel trim on the right of the car and unscrew the four bolts that join the backend blend door actuator to the metal wall of the rear HVAC unit. Unplug the rear HVAC wire harness connector from the rear blend door actuator and remove the actuator from its spot in the housing. To install, put the rear blend door actuator next to the rear HVAC housing, checking that the spline on the actuator's shaft lines up with the spline on the rear actuator coupler. Secure the actuator by adding the screws and tightening each to 2 N.m (17 in. lbs.). Plug in the back HVAC wire harness at the actuator, wedge the quarter panel trim into place and attach the other end of the negative battery cable. After that, go to the Actuator Calibration function using a scan tool.

Related 2006 Dodge Durango Parts

Alternate Year Models

+
2005 Dodge Durango Blend Door Actuator 2007 Dodge Durango Blend Door Actuator