How to Remove a Starter Motor from a 3.7L or 4.7L Engine on Dodge Dakota?

For a 3.7L or 4.7L engine with a manual transmission, start by isolating the negative battery cable, next lift and hold the car up. If you have 4WD and specific transmissions, remove the two support bracket bolts at the transmission and lightly pry the bracket aside to reach the lower starter bolt. After checking the belt tension, remove both a bolt and a nut from the transmission, if you have a manual version. Move the starter motor forward until the nose of its casing clears the other housing area and be sure to support the starter so it doesn't hang from the wire harness. Move the nose close to the ground and have the starter motor at a level that allows you to remove the nut joining the battery positive cable wire harness connector eyelet with the solenoid battery terminal stud. First, remove the positive cable wire from the solenoid terminal and since connected. Disconnect the negative battery cable, then raise the vehicle as you would for any other engine. With an automatic transmission, release the bolts as detailed and then lift, angle and disconnect the starter motor just as you would for a manual transmission.

How to Install a Starter Motor for a 3.7L or 4.7L Engine with Manual or Automatic Transmission on Dodge Dakota?

When managed transmission is used, join the solenoid wire to the starter to make sure it snaps firmly. Fasten the battery cable to the solenoid stud and then use the nut to tighten the eyelet. Fasten the starter motor to the transmission, but don't let the starter motor hang from the wire harness and install and tighten the lockwasher nut and bolt. Move the car down and secure the negative side of the cable close to the battery. If your car has an automatic transmission and a solenoid-controlled starter motor, connect the solenoid wire to the starter motor, place the battery cable at the solenoid's stud, make sure the battery cable's eyelet nut is installed and tightened and ensure that the starter does not fall from its wire harness. Put the starter motor onto the transmission, put the cooler tube bracket in place if you have one and screw in and tighten the two bolts. Take down the lifted vehicle and put the negative battery cable on first.

OEM Dodge Dakota Starter Motor

Starter Ignition

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

11 Starter motors found

View related parts
Dodge Dakota Starter Part Number: 4801256AC
$273.50 MSRP: $402.00
You Save: $128.50 (32%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Engine
- Replaces: 4801256AA, 4801256AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2006-2010 Dodge Dakota | Big Horn, Laramie, Lone Star, SLT, ST, SXT, Sport, TRX, TRX4 | 3.7L V6, 4.7L V8, 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS
View related parts
Dodge Dakota Starter Part Number: 4796981AB
$239.06 MSRP: $352.00
You Save: $112.94 (33%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Starter Motor; Starter Engine
- Replaced by: 4796981AE
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1997-1999 Dodge Dakota | Base, SLT, Sport | 4 Cyl 2.5 L GAS
View related parts
Dodge Dakota Starter Part Number: R6027702AC
$188.42 MSRP: $275.00
You Save: $86.58 (32%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Engine
- Replaces: 56027702AB, 56027702AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1999-2003 Dodge Dakota | Base, R/T, SLT, SXT, Sport | 3.9L V6, 4.7L V8, 5.9L V8, 6 Cyl 3.9 L GAS, 8 Cyl 4.7 L GAS, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS
View related parts
Dodge Dakota Starter Part Number: 56027702AD
$206.85 MSRP: $271.00
You Save: $64.15 (24%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Engine
- Replaces: 4801257AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2004-2009 Dodge Dakota | Base, Big Horn, Laramie, Lone Star, SLT, SLT Plus, ST, SXT, Sport, Sport Plus, TRX, TRX4 | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS
View related parts
Dodge Dakota Starter Part Number: 56028715AD
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Engine
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2002-2003 Dodge Dakota | Base, SLT, Sport | 8 Cyl 4.7 L GAS
View related parts
Dodge Dakota Starter Part Number: 56029113AA
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Engine
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2004-2005 Dodge Dakota | Base, Laramie, SLT, SLT Plus, ST, SXT, Sport, Sport Plus | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L GAS
View related parts
Dodge Dakota Starter Part Number: R6028715
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Engine
- Replaces: 56028715
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2000-2002 Dodge Dakota | Base, SLT, Sport | 4.7L V8, 8 Cyl 4.7 L GAS
View related parts
Dodge Dakota Starter Part Number: 56041013AF
Product Specifications
- Other Name: Starter - Engine; Starter Motor
- Replaces: 56041013AE, 56041013AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1999 Dodge Dakota | Base, SLT, Sport | 2.5L L4, 4 Cyl 2.5 L GAS
View related parts
Dodge Dakota Starter Part Number: 53005984AB
Product Specifications
- Other Name: Starter - Engine
- Replaces: 53005984, R3005984
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1990-1996 Dodge Dakota | Base, LE, S, SE, SLT, Sport, WS | 2.5L L4, 3.9L V6, 5.2L V8, 6 Cyl 3.9 L GAS, 8 Cyl 5.2 L CNG, 8 Cyl 5.2 L GAS
View related parts
Dodge Dakota Starter Part Number: 4671130
Product Specifications
- Other Name: Starter - Assembly - Dw-1.1Kw; Starter Motor Reman; Starter Motor; Starters; Starter, 4 Cylinder 2.5 Engine; Starter, 4 Cylinder; Starter, Assembly
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1987-1996 Dodge Dakota | Base, LE, S, SE, SLT, Sport, WS | 4 Cyl 2.2 L GAS, 4 Cyl 2.5 L GAS
View related parts
Dodge Dakota Starter Part Number: 4796981AE
Product Specifications
- Other Name: Starter - Engine
- Replaces: 4796981AC, 4796981AB, 4796981AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1997-1999 Dodge Dakota | Base, SLT, Sport | 4 Cyl 2.5 L GAS

Dodge Dakota Starter Motor

Choose OEM Starter Motor that meet Dodge factory standards. Dodge designs and tests every component for precision and durability. Each Starter Motor follows strict manufacturing steps to lock in quality and fit. If your Dodge Dakota matters to you, OEM parts make the smart choice. You'll get the exact look, feel, and performance you expect. Shop genuine Dakota parts at the highly competitive prices online. Enjoy a manufacturer's warranty, a hassle-free return policy, and rapid delivery. No more guesswork with off brands. Get genuine parts with exact fit and true factory performance. Shop with confidence today at JeepPartsDeal.com.

Starter Motor Motor is used in Dodge Dakota vehicles Compact pickup Trucks to convert the electrical energy from the battery into mechanical energy to crank the engine. It is powered by an externally offset solenoid which is tapped to the battery to energize the starter motor. In the starter, there is a rotating armature which is identical with the field coils or permanent magnets in order to produce requisite torque. It consists of a starter drive that gets in touch with the flywheels of the engine once the ignition is started, and an overrunning clutch that disengages the starter as soon as the engine starts running. Through the years, there were different versions of the Dodge Dakota and the type of starter used in the models of the car are usually electric starters as these are the most popular types. There are gear reduction starters which have made it more efficient and smaller than before. Nevertheless, the standard OE starters may not work properly with the high-compression engines and this may lead to some failure. Therefore, performance applications are likely to necessitate the use of special starters which are normally more durable together with performing better.

Dodge Dakota Starter Motor Parts and Q&A

Starter
4801256AC
Q: How to Remove a Starter Motor from a 3.7L or 4.7L Engine on Dodge Dakota?
A:
For a 3.7L or 4.7L engine with a manual transmission, start by isolating the negative Battery Cable, next lift and hold the car up. If you have 4WD and specific transmissions, remove the two support bracket bolts at the transmission and lightly pry the bracket aside to reach the lower starter bolt. After checking the belt tension, remove both a bolt and a nut from the transmission, if you have a manual version. Move the starter motor forward until the nose of its casing clears the other housing area and be sure to support the starter so it doesn't hang from the wire harness. Move the nose close to the ground and have the starter motor at a level that allows you to remove the nut joining the battery positive cable wire harness connector eyelet with the solenoid battery terminal stud. First, remove the positive cable wire from the solenoid terminal and since connected. Disconnect the negative battery cable, then raise the vehicle as you would for any other engine. With an automatic transmission, release the bolts as detailed and then lift, angle and disconnect the starter motor just as you would for a manual transmission.
Starter
56027702AD
Q: How to Install a Starter Motor for a 3.7L or 4.7L Engine with Manual or Automatic Transmission on Dodge Dakota?
A:
When managed transmission is used, join the solenoid wire to the starter to make sure it snaps firmly. Fasten the Battery Cable to the solenoid stud and then use the nut to tighten the eyelet. Fasten the starter motor to the transmission, but don't let the starter motor hang from the wire harness and install and tighten the lockwasher nut and bolt. Move the car down and secure the negative side of the cable close to the battery. If your car has an automatic transmission and a solenoid-controlled starter motor, connect the solenoid wire to the starter motor, place the battery cable at the solenoid's stud, make sure the battery cable's eyelet nut is installed and tightened and ensure that the starter does not fall from its wire harness. Put the starter motor onto the transmission, put the cooler tube bracket in place if you have one and screw in and tighten the two bolts. Take down the lifted vehicle and put the negative battery cable on first.