You must first remove the negative battery cable and evacuate the refrigerant inside the A/C system to remove the condenser. You should open the cooling system cap when the fluid temperature is under 90°C, covering it with your gloved hand and adjusting it slowly. Stop the cooling system from overheating by turning the radiator cap on reservoir to catch number "1", and then take off the radiator fan and the coolant reservoir (1). After that, unlink the refrigerant lines (1) from the condenser, ease open the mount for the connection fittings (1-2), lean forward the radiator and remove the condenser. When you install the condenser, put it in position and tighten the condenser connection mount fittings (1-2). Tighten the refrigerant lines back onto the condenser to 24 Nm (18 ft. lbs.). Next, put on the radiator, lower radiator hose, upper radiator hose, radiator fan and coolant reservoir. Fill the coolant, put refrigerant into the refrigerant system, then reattach the negative battery cable at the end.